Department Of Life Safety And Environmental Protection 1
1. Theoretical Researching of Particle Movement in Cleaning Zone of Dust-Arrester
2. Evaluation of the Biological Efficiency of Water Disinfection Using High-Frequency Electrical Discharge
3. Studies on the Production of a Ground Silicate Composite Based on a Mineral Slag Binder with the Disposal of Industrial Waste
4. THERMAL INSULATING MATERIALS BASED ON MAGNESIUM-CONTAINING TECHNOGENIC RAW MATERIALS
5. STUDY OF THE TECHNOGENIC IMPACT OF MOTOR TRANSPORT ON THE ENVIRONMENT IN CITIES
6. Comparative Study of the NOx, CO Emissions, and Stabilization Characteristics of H2-Enriched Liquefied Petroleum Gas in a Swirl Burner
7. Investigation of the Influence of Various Methods of Cotton Harvesting on its Pollution and Other Qualitative Indicators
8. Analysis of Forecast Scenarios of Hazardous Factors Affecting the Shift Settlement of an Oil Field Indicators
9. Comparison of the Quality of Gas Equipment at Metallurgical and Coke-Chemical Enterprises and Production Plants
10. MATHEMATICAL DESCRIPTION OF THE PROCESS OF FILM CONDENSATION OF VAPORS FROM STEAM-GAS MIXTURES
11. THEORETICAL STUDIES OF THE HEAT TRANSFER PROCESS AND THE HYDRODYNAMICS OF A CONDENSATE FILM BY NUMERICAL EXPERIMENT
12. Development of method for calculation of pre-strained steel cylindrical sheaths in view of the winding angle, pitch and thickness
13. Studies of Sustainable Desalination of Groundwater Using a Membrane Apparatus
14. Study on the Composition and Environmental Impact of Sewage Sludge
15. WORLD EXPERIENCE IN THE USE OF EXCESS SEWAGE SLUDGE
16. Green processing of industrial waste and obtaining adsorbent for purification of sulfur dioxide
17. Improvement of Methods of Analysis and Forecasting of Industrial Injuries in the Electric Workshop of the Mining and Processing Plant
18. Modeling of Non‐Ferrous Metallurgy Waste Disposal with the Production of Iron Silicides and Zinc Distillation
19. THERMODYNAMIC MODELING OF THE FORMATION OF THE MAIN MINERALS OF CEMENT CLINKER AND ZINC FUMES IN THE PROCESSING OF TOXIC TECHNOGENIC WASTE OF THE METALLURGICAL INDUSTRY
20. The challenges of reusing thermal power plant wastes to produce cellular concrete modified with wollastonite
21. Production of Composite Cement Clinker Based on Industrial Waste
22. Investigation of the Possibility of Utilizing Man-Made Waste to Produce Composite Binders
23. Protein, Amino Acid and Carbohydrate Content of Fungal Treated Annual and Perennial Wheat Straw
24. ADSORPTION OF ACTIVE CHLORINE AND TECHNOLOGY OF AN AQUEOUS SOLUTION DECHLORINATION BY MODIFIED ACTIVATED CARBON
25. DETERMINATION OF THE COMPONENT COMPOSITION OF PHENOLIC EXTRACTS FROM THE PURIFICATION OF PETROLEUM OILS
26. PRODUCTION OF MODIFIED SORBENT BASED ON PEACH SHELLS
27. Physico-Chemical Study of the Possibility of Utilization of Coal Ash by Processing as Secondary Raw Materials to Obtain a Composite Cement Clinker
28. STUDY OF THE USE OF PHENOLIC EXTRACT AS A PLASTICIZER IN THE PRODUCTION OF LINOLEUM
29. Study on the Possibilities of Utilizing Wastes of Polymetallic Combines in South Kazakhstan for the Production of Composite Heavy Concrete
30. THE RESULTS OF LABORATORY STUDIES ON THE COMPOSITION OF ROOFING AND WATERPROOFING MASTICS
31. Research on the Production of Pigments Based on Composite Pellets in the Recycling of Industrial Waste
32. Analysis of strength and eigenfrequencies of a steel vertical cylindrical tank without liquid, reinforced by a plain composite thread
33. Neural networks for predicting oil refinery accidents
34. Effect of thermomechanical processing of building stainless wire to increase its durability
35. Improvement of strength and performance properties of copper wire during severe plastic deformation and drawing process
36. Increasing strength and performance properties of bimetallic rods during severe plastic deformation
37. Study of changes in microstructure and metal interface Cu/Al during bimetallic construction wire straining
38. Study of the Properties of Antifriction Rings under Severe Plastic Deformation
39. Long term changes in the quality of the aquatic environment of thermally polluted Lake Licheńskie, Central Poland
40. Trace gas (CH4, N2O, H2S) distribution in the water column of inland lakes in Poland
41. Analysis of a Stress-Strain State of a Cylindrical Tank Wall Vertical Field Joint Zone
42. Analysis of Stress-Strain State for a Cylindrical Tank Wall Defected Zone
43. Analysis of the influence of thermal insulation material on the thermal resistance of new facade structures with horizontal air channels
44. Energy-Efficient Outdoor Fencing with Air Layers: A Review of the Effect of Solar Radiation on the Exterior Fencing of Buildings Made of Composite Material
45. Experimental research of the stress-strain state of prestressed cylindrical shells taking into account temperature effects
46. Factors affecting extended avalanche destructions on long-distance gas pipe lines: Review
47. Field thermal imaging surveys of residential buildings – a prerequisite for the development of energy-efficient external enclosures
48. Multilayer External Enclosing Wall Structures with Air Gaps or Channels
49. Study of the model of the phase transition envelope taking into account the process of thermal storage under natural draft and by air injection
50. Thermophysical indicators of elaborated sandwich cladding constructions with heat-reflective coverings and air gaps
1