SIMULATION OF THE FORGING PROCESS WITH AN ADDITIONAL MACRO-SHIFT IN “DEFORM” SOFTWARE PACKAGE
Lezhnev S. Naizabekov A. Panin E. Kuis D. Stepankin I.
2022University of Chemical Technology and Metallurgy
Journal of Chemical Technology and Metallurgy
2022#57Issue 1195 - 204 pp.
The paper presents the results of computer simulation of the process of forging round blanks in the strikers of the new design. It is shown that the use of a radial joint of the faces has a favorable effect on the stress distribution along the entire length of the metal-tool contact. The analysis of models with different angles of inclination of flat faces showed that the best option is to use strikers with an angle of 30°, since in this case a fairly extensive distribution of strain over the cross section occurs in the workpiece with a significantly lower deformation force than when using strikers with an angle of 0°. The analysis of the technological parameters influence on the microstructure evolution showed that the most optimal workpiece heating temperature is 1000°C, while all 3 variants of the punch speed can be recommended for the implementation of this process in practice.
broaching , computer modeling , force , forging , microstructure evolution , shear deformation , stress-strain state
Text of the article Перейти на текст статьи
Rudny industrial Institute, 50 let Oktyabrya str. 38, Rudny, 115000, Kazakhstan
Karaganda Industrial University, Republic av. 30, Temirtau, 101400, Kazakhstan
Belarusian State Technological University Sverdlova, str.13a, Minsk, 220006, Belarus
Pavel Sukhoi State Technical University of Gomel Oktyabrya, av 48, Gomel, 246746, Belarus
Rudny industrial Institute
Karaganda Industrial University
Belarusian State Technological University Sverdlova
Pavel Sukhoi State Technical University of Gomel Oktyabrya
10 лет помогаем публиковать статьи Международный издатель
Книга Публикация научной статьи Волощук 2026 Book Publication of a scientific article 2026