IMPROVEMENT AND RESEARCH OF A NEW COMBINED METHOD FOR PRODUCING SCREW FITTINGS USING COMPUTER MODELING
Lezhnev S. Tolkushkin A. Panin E. Shiriaeva E. Tsyba P.
3 September 2025University of Chemical Technology and Metallurgy
Journal of Chemical Technology and Metallurgy
2025#60Issue 5869 - 876 pp.
This paper presents the results of modelling a combined process of radial-shear rolling and pressing in order to obtain a reinforcing profile at different rotation speeds of the screw matrix. The parameters of the stress-strain state in the zones of radial-shear rolling and the formation of a screw profile in the matrix on the surface and axial parts of the workpiece were analysed. It has been established that the forced rotation of the screw matrix not only helps to increase the process performance but also plays an important role in preventing the defects formation. The maximum value of the equivalent strain is achieved in a fixed matrix, the higher the rotation speed of the matrix, the lower the values of the equivalent strain. At the same time, in the case of a high rotation speed of the die, the minimum strain level is 10 approximately. Stress state analysis has shown that this deformation scheme creates a high level of compressive stresses, which are dominated by tensile stresses.
combined process , damage criterion , FEM modelling , screw profile , stress-strain state
Text of the article Перейти на текст статьи
Rudny Industrial University, Rudny, 111500, Kazakhstan
Karaganda Industrial University, Temirtau, 101400, Kazakhstan
Nosov Magnitogorsk State Technical University, Magnitogorsk, 455000, Russian Federation
Rudny Industrial University
Karaganda Industrial University
Nosov Magnitogorsk State Technical University
10 лет помогаем публиковать статьи Международный издатель
Книга Публикация научной статьи Волощук 2026 Book Publication of a scientific article 2026