A Simulation of the Process of High Speed Milling of Titanium Alloy VT-1-0 in DEFORM-3D

Sherov K. Tussupova S. Kuzminova N. Makhmudov L. Mardonov B. Ainabekova S. Abdugaliyeva G. Kokayeva G. Mendalieva S. Kardassinov S.
6 October 2025 Dr D. Pylarinos

Engineering, Technology and Applied Science Research
2025 #15 Issue 5 26703 - 26710 pp.

This study examined the High-Speed Milling (HSM) process of titanium alloy VT-1-0 using the Deform-3D simulation software. The simulation modeled the HSM operation and analyzed the distribution of temperature and strain in the cutting zone. The results indicated that deformation primarily occurred at the tool-workpiece interface and propagated more intensely into the sheared material at an angle of approximately 45°. Increasing the spindle speed of the end mill led to greater strain values in the cutting zone. Due to the low thermal conductivity of titanium, high temperatures-exceeding 1500 °C were localized at the tool-workpiece contact area. This concentration of heat, coupled with its slow dissipation throughout the workpiece, negatively affected the surface quality and tool life. Additionally, increasing both the feed rate and cutting speed resulted in higher temperatures and intensified friction at the interface. The findings of this simulation provided valuable insights for optimizing the cutting parameters and better understanding the machinability of titanium under HSM conditions.

cutting parameters , deformation , High-Speed Milling (HSM) , modeling , temperature , titanium machinability

Text of the article Перейти на текст статьи

S. Seifullin Kazakh Agrotechnical Research University (KATRU), Astana, 010011, Kazakhstan
Toraighyrov University, Pavlodar, 140008, Kazakhstan
Karaganda Industrial University, Temirtau, 101400, Kazakhstan
Navoi State Mining and Technology University, Navoi, 210100, Uzbekistan
Abylkas Saginov Karaganda Technical University, Karaganda, 100027, Kazakhstan

S. Seifullin Kazakh Agrotechnical Research University (KATRU)
Toraighyrov University
Karaganda Industrial University
Navoi State Mining and Technology University
Abylkas Saginov Karaganda Technical University

10 лет помогаем публиковать статьи Международный издатель

Книга Публикация научной статьи Волощук 2026 Book Publication of a scientific article 2026