Impact of gas pressure and spray distance on coating formation in electric arc metallization
Rakhadilov B.K. Magazov N.M. Molbossynov Y.S. Apsezhanova A.K. Kussainov A.Y.
23 June 2025al-Farabi Kazakh State National University
Physical Sciences and Technology
2025#12Issue 1-214 - 26 pp.
This study investigates the technological parameters of electric arc metallization applied to 30KHGSA steel, focusing on the effects of varying the spraying distance (100–250 mm) and gas pressure (6–9 Pa) on the resulting coating structure and properties. The spraying was performed using an SX-600 electric arc metallizer. Electron microscopy and metallographic analysis revealed that the coatings possess a layered structure consisting of solidified convective metal flows, micro-welded particles, and oxide inclusions. The optimal spraying parameters–150 mm distance and 7 Pa pressure–yielded the maximum coating thickness (729.58–733.62 μm) and the lowest porosity (4.02–4.33%). It was observed that increasing the spraying distance beyond 150 mm leads to reduced coating thickness, while deviations from the optimal gas pressure result in decreased structural density and homogeneity. Electric arc metallization of 30KHGSA steel under optimal conditions enables the formation of coatings with enhanced wear resistance and mechanical strength. Specifically, spraying distances over 150 mm and pressures outside the 7–8 Pa range negatively affect the coating’s density, uniformity, and tribological performance. The identified optimal range (150–200 mm, 7–8 Pa) promotes the development of coatings with low surface roughness, reduced friction coefficient, and improved wear resistance.
arc spraying , microstructure , porosity , steel coatings , thickness , Vickers hardness
Text of the article Перейти на текст статьи
PlasmaScience LLP, Ust-Kamenogorsk, Kazakhstan
Daulet Serikbayev East Kazakhstan Technical University, Ust-Kamenogorsk, Kazakhstan
PlasmaScience LLP
Daulet Serikbayev East Kazakhstan Technical University
10 лет помогаем публиковать статьи Международный издатель
Книга Публикация научной статьи Волощук 2026 Book Publication of a scientific article 2026