Studying the stress-strain state of a more loaded node of a special device for turn-milling
Mussayev M.M. Sherov K.T. Buzauova T.M. Rakishev A.K. Karsakova N.Z. Abisheva N.B. Ainabekova S.S.
January 2022Faculty of Metallurgy
Metalurgija
2022#61Issue 1247 - 249 pp.
This article presents the results of studying the stress-strain state of the intermediate shaft part, which is subjected to high dynamic loads during the operation of a special device for turn-milling. The values and the nature of the stress distribution in the body of the intermediate shaft are determined using a special software package ANSYS Workbench. The scheme of forces acting on the intermediate shaft has been revealed. The calculation is based on the method of determining the von Mises yield criterion. It has been established that the maximum value of the voltage and the most critical point occurs at the transition of the steps from the diameter of 25 mm to 30 mm. However, the value of these stresses does not exceed the maximum permissible ones and it can be concluded that the parametric dimensions of the intermediate shaft fully meet the requirements to ensure the quality of the device.
Shaft , Software , Strain , Stress , Turn-milling
Text of the article Перейти на текст статьи
Karaganda Technical University, Karaganda, Kazakhstan
Karaganda Industrial University, Temirtau, Kazakhstan
Karaganda Technical University
Karaganda Industrial University
10 лет помогаем публиковать статьи Международный издатель
Книга Публикация научной статьи Волощук 2026 Book Publication of a scientific article 2026