Parametric Optimization of a New Gear Pump Casing Based on Weight Using a Finite Element Method
Zharkevich O. Nikonova T. Gierz Ł. Berg A. Berg A. Zhunuspekov D. Warguła Ł. Łykowski W. Fryczyński K.
November 2023Multidisciplinary Digital Publishing Institute (MDPI)
Applied Sciences (Switzerland)
2023#13Issue 22
Reducing the weight of the structures and choosing the materials used in mechanical engineering is an important and pressing economic and environmental problem. The design of a gear pump is developed from the point of view of the geometry of the gears, as well as the casing. This paper tested a gear pump casing using the environment of the ABAQUS 2020 system in the field of statistical strength analysis using the finite element method. The tests were carried out on the pump body and the front and rear covers, which were made of three types of materials (cast iron, aluminum, and polycarbonate), at a pressure of 28 MPa. After loading, the maximum stresses in the aluminum casing (177 MPa), the cast iron casing (157 MPa), and the polycarbonate (200 MPa) were determined. The largest stress concentrators are the grooves at the bottom of the pump casing. Rounding the internal chamber of the casing with a radius of 4 mm made it possible to reduce stress in this zone by 10 MPa. The parametric optimization of the front and back covers of the gear pump made it possible to reduce the total weight of the aluminum structure by 14%, the cast iron by 12%, and the polycarbonate by 16%. The 3D models show areas of minimal stress where the size and weight of the structure could be reduced in the future using a comprehensive approach involving parametric and topological analysis.
fatigue , part , safety factor , simulation , stress
Text of the article Перейти на текст статьи
Department of Technological Equipment, Mechanical Engineering and Standardization, Abylkas Saginov Karaganda Technical University, Karaganda, 100027, Kazakhstan
Institute of Machine Design, Faculty of Mechanical Engineering, Poznan University of Technology, Poznan, 60-965, Poland
Department of Technological Equipment
Institute of Machine Design
10 лет помогаем публиковать статьи Международный издатель
Книга Публикация научной статьи Волощук 2026 Book Publication of a scientific article 2026