Simulation of Hot Casting Shrinkage of Thermoplastic Beryllium Oxide Slurries with Ultrasonic Activation
Zhapbasbayev U. Sattinova Z. Ramazanova G.
December 2024Engineered Science Publisher
Engineered Science
2024#32
The article proposes a method for calculating the shrinkage of hot casting of thermoplastic beryllium oxide slurries. The thermoplastic slurry (hereinafter referred to as slurry) is a composition system with a dispersed phase (binder) having a low thermal conductivity compared to the dispersed phase (beryllium oxide). Ultrasonic treatment reduces the viscosity of the slurry and improves its casting properties. The hot casting of beryllium oxide slurry is carried out without breaking the continuity of the system and depends on speed and temperature factors. Cooling-solidification of the slurry in the casting unit takes place in stages in a liquid state, a crystallization state with a phase transition, and a plastic state of the casting. The cooling rate of the casting at all stages depends on the design of the cavity, the rheological properties of the slurry, and the casting speed. The novelty of the work is the determination of shrinkage by the distribution of the concentration of the kinetically free binder. The slurry near the cooled wall is in a state of crystallization and plasticity, and the other part may still be in the liquid phase. Along the cavity cross-section, there is the inhomogeneous distribution of temperature, density, and concentration of kinetically free binder. This leads to compensation of shrinkage by the inflow of slurry from the liquid into the crystallization zones and the plasticity of the casting.
Beryllium oxide , Hot casting , Shrinkage , Thermoplastic slurry moulding , Ultrasonic activation
Text of the article Перейти на текст статьи
Scientific Laboratory “Energy Modeling”, Satbayev University, str. Satbayev 22, Almaty, 050013, Kazakhstan
Department of Power Engineering, Faculty of Transport and Energy, L.N. Gumilyov Eurasian National University, Astana, 010008, Kazakhstan
Scientific Laboratory “Energy Modeling”
Department of Power Engineering
10 лет помогаем публиковать статьи Международный издатель
Книга Публикация научной статьи Волощук 2026 Book Publication of a scientific article 2026