New Solutions in Pipe Billet Production
Zhakupova A. Zhakupov A. Bogomolov A.
December, 2024Dr D. Pylarinos
Engineering, Technology and Applied Science Research
2024#14Issue 617945 - 17949 pp.
This paper proposes a method for determining the speed of hollow steel billet casting to produce seamless oil and gas pipes. At the same time, the use of hollow billet excludes, in the technological process of pipe production, the piercing of the billet. The results of industrial production modeling were recalculated into natural quantities according to the Fourier number similarity criterion. The calculations determined that the optimal drawing speed and casting speed of a billet with a diameter of 210 mm are 2.01 m/min and 0.273 t/min, respectively. At the same time, productivity increased by 16%, compared to the one when casting a solid billet. To ensure the homogeneity of structure and mechanical properties over the entire cross-section of the hollow billet, the optimum ratio of coolant flow rates into the inner cavity and outside the billet in the secondary cooling zone was determined, considering the area of the cooled surface, which is equal to 1.46.
casting speed , hollow billet , secondary cooling zone
Text of the article Перейти на текст статьи
Department of Metallurgy, Toraighyrov University, Pavlodar, Kazakhstan
Department of Metallurgy
10 лет помогаем публиковать статьи Международный издатель
Книга Публикация научной статьи Волощук 2026 Book Publication of a scientific article 2026