On the Possibility of Forming a Corium Pool by Induction Heating in a Melt Trap of the Lava-B Facility
Skakov M. Baklanov V. Akaev A. Kukushkin I. Bekmuldin M. Toleubekov K. Gradoboev A. Stepanova O.
February 2023MDPI
Applied Sciences (Switzerland)
2023#13Issue 4
This paper presents the results of computational and physical studies on the production of corium and its retention in an MR’s melt trap of the Lava-B facility. A feature of the Lava-B facility used in the IAE NNC RK to study the processes occurring during a severe accident at a nuclear reactor, is the separation of the stages of the reactor core corium formation and its interaction with structural materials. The melting of materials takes place in an induction furnace with a hot crucible, after which it moves to a melt receiver (MR) in which the test object is located. In the case of studies of processes occurring outside the reactor vessel, this is a special trap, which is placed in the inductor to simulate decay heat. However, based on the conservative computational estimates, it was found that the inductor power in the MR can be sufficient to directly produce, melt, and, subsequently, maintain the corium in the liquid phase. In this regard, in order to optimize the experiments under controlled conditions, the authors came up with the idea to experimentally test the possibility of producing corium by induction heating directly in the MR’s melt trap. In addition, according to the authors, this method would obviate the problem of corium contact with the carbon environment of the melting furnace of the Lava-B facility. Previously, burden heating simulating corium was modeled on the computer using available parameters of the MR’s induction heater. Based on the numerical experiment, the conditions for physical modeling of the corium production in the MR’s melt trap were established. An analysis of the physical modeling showed that during the burden heating in the melt trap, its metal components became liquid, thus, forming a melt pool. However, in terms of this design of the trap, there were problems associated with the complete melting of all corium components, as well as with the integrity of the experimental device when forming the corium pool and during the actual physical modeling.
core , corium , induction heating , Lava-B facility , severe accident
Text of the article Перейти на текст статьи
National Nuclear Center of the Republic of Kazakhstan, Kurchatov, 071100, Kazakhstan
Institute of Atomic Energy NNC RK, Kurchatov, 071100, Kazakhstan
The Engineering-Technological Faculty, Shakarim University, Semey, 071412, Kazakhstan
Department of Experimental Physics, National Research Tomsk Polytechnic University, Tomsk, 634050, Russian Federation
National Nuclear Center of the Republic of Kazakhstan
Institute of Atomic Energy NNC RK
The Engineering-Technological Faculty
Department of Experimental Physics
10 лет помогаем публиковать статьи Международный издатель
Книга Публикация научной статьи Волощук 2026 Book Publication of a scientific article 2026