INVESTIGATION OF THE METHOD OF THERMAL FRICTION TURN-MILLING OF HIGH STRENGTH MATERIALS
Sherov K. Mussayev M. Usserbayev M. Magavin S. Abisheva N. Karsakova N. Kuanov I. Bekzhanov Y. Myrzakhmet B.
2022Institute for Educational Research
Journal of Applied Engineering Science
2022#20Issue 113 - 18 pp.
An analysis of the state of the matter of the manufacture of parts such as bodies of revolution has shown that there is a problem of turning processing by turning large, long parts, connected with increasing productivity and processing quality, as well as reducing the costs of turning operations. To solve this problem, the authors propose a resource-saving combined method for treating external cylindrical surfaces by thermal friction turn-milling. Experimental studies were performed on the processing of the outer cylindrical surface using a special friction cutter made of non-instrumental material. The results showed that with thermal friction turn-milling, it is possible to achieve Ra = 1,0 mcm. The process of chip formation was also investigated and the formation of a retarded layer was established, which protects the surface of the friction cutter from wear. Optimum values of cutting conditions for processing by thermal friction turn-milling of steel 30HGSA.
braked layer , feed motion , hardness , high strength material , roughness , thermal friction turn-milling
Text of the article Перейти на текст статьи
S. Seifullin Kazakh Agro Technical University, Technical faculty, Nur-Sultan, Kazakhstan
Karaganda Technical University, Mechanical Engineering faculty, Karaganda, Kazakhstan
S. Seifullin Kazakh Agro Technical University
Karaganda Technical University
10 лет помогаем публиковать статьи Международный издатель
Книга Публикация научной статьи Волощук 2026 Book Publication of a scientific article 2026