The Phenomenon of Magnetic Anisotropy in Amorphous Materials Produced Using the Injection-Casting Method
Nabiałek M. Wysłocki J.J. Jaruga T. Błoch K. Sandu A.V. Savinkin V.V. Salleh M.A.A.M. Jeż B.
2023Polska Akademia Nauk
Acta Physica Polonica A
2023#144Issue 5410 - 413 pp.
The magnetisation process of magnetic materials is extremely important due to the potential applications of these materials. During the magnetisation process, a delay in the increase in magnetisation is observed when the magnetic field strength increases. This behaviour may be explained by the magnetic anisotropy of the studied material. The paper presents the results of research on primary magnetisation curves for magnetic alloys that exhibit soft-magnetic properties. The tested alloys are the so-called amorphous materials in which determining the preferred direction of magnetisation is difficult due to their structure. However, as our research indicates, it is in fact possible to distinguish directions of relatively easy and difficult magnetisation in amorphous materials, which implies that the phenomenon of magnetic anisotropy occurs in them.
injection casting method , primary magnetisation curve , saturation magnetisation , topics: magnetic anisotropy
Text of the article Перейти на текст статьи
Department of Physics, Faculty of Production Engineering and Materials Technology, Czestochowa University of Technology, al. Armii Krajowej 19, Częstochowa, 42-200, Poland
Department of Technology and Automation, Faculty of Mechanical Engineering and Computer Science, Czestochowa University of Technology, Al. Armii Krajowej 19c, Częstochowa, 42-200, Poland
Faculty of Material Science and Engineering, Gheorghe Asachi Technical University, 64 Dumitru Mangeron Blvd, Iaşi, 700050, Romania
Academy of Romanian Scientists, 54 Splaiul Independentei St., Sect. 5, Bucharest, 050094, Romania
Department “Transport and Mechanical Engineering”, Faculty of Transport and Mechanical Engineering, M. Kozybayev North Kazakhstan University, 86 Pushkin str., Petropavlovsk, 150000, Kazakhstan
Center of Excellence Geopolymer and Green Technology, Universiti Malaysia Perlis, Taman Muhibbah, Perlis, Arau, 02600, Malaysia
Faculty of Chemical Engineering and Technology, Universiti Malaysia Perlis, Taman Muhibbah, Perlis, Arau, 02600, Malaysia
Department of Physics
Department of Technology and Automation
Faculty of Material Science and Engineering
Academy of Romanian Scientists
Department “Transport and Mechanical Engineering”
Center of Excellence Geopolymer and Green Technology
Faculty of Chemical Engineering and Technology
10 лет помогаем публиковать статьи Международный издатель
Книга Публикация научной статьи Волощук 2026 Book Publication of a scientific article 2026