Chip formation during thermal friction turn miliing

Mussayev M. Sherov K. Taskarina A. Sherov A. Gabdyssalik R. Buzauova T. Ainabekova S.
2021 Institut za Istrazivanja

Journal of Applied Engineering Science
2021 #19 Issue 1 142 - 147 pp.

This paper presents the results of chip formation studies in the processing of 30KhGSA steel by thermofriction turn-milling. When studying the process in this work there are presented the results of studying chip formation when the processing of chip formation there is used the metallographic method. Chip root area investigated.The dependence of the chip shrinkage coefficient on the cutting speed and feed was also investigated. It is established that with increasing supply S the value of the chip shrinkage coefficient K decreases. The higher the chip shrinkage factor, the more work will be required to cut the chips and the more complex the processing process.

Chip root , Plastic deformation , Slowed-down layer , Structural angle , Thermofrictional turn-milling

Text of the article Перейти на текст статьи

Karaganda Technical University, Mechanical Engineering faculty, department Technological equipment mechanical engineering and standardization, Karaganda, Kazakhstan
Pavlodar University, Mechanical Engineering faculty, Department of Metallurgy, Pavlodar, Kazakhstan
LlP «Kazakhstan Aviation Industry», Nur-Sultan, Kazakhstan
D.Serikbayev East Kazakhstan University, Mechanical Engineering faculty, Department of mechanical engineering, Ust-Kamenogorsk, Kazakhstan

Karaganda Technical University
Pavlodar University
LlP «Kazakhstan Aviation Industry»
D.Serikbayev East Kazakhstan University

10 лет помогаем публиковать статьи Международный издатель

Книга Публикация научной статьи Волощук 2026 Book Publication of a scientific article 2026