FEATURES OF TESTING PILES FOR HIGH-RISE BUILDINGS IN DIFFICULT SOIL CONDITIONS IN ASTANA
Mussakhanova S. Zhussupbekov A. Omarov A. Abilmazhenov T. Issakulov A.
2023GEOMATE International Society
International Journal of GEOMATE
2023#25Issue 110106 - 113 pp.
The project consists of a high-rise building supported on boring and driven piles. An assessment was made of the current practice in the foundation design of high-rise buildings in Astana, Kazakhstan, to explore areas for improvement. Pile testing is usually undertaken to provide relevant information on one or more of the following issues: the ultimate load capacity of a single pile, the load-settlement behavior of a pile, the acceptability of the performance of a pile, and the structural integrity of a pile. A three-stage process of foundation design and verification will be described, and the importance of proper ground characterization and assessment of geotechnical parameters will be emphasized. According to the test results, the bearing capacity of driven and bored piles was determined, and a comparative analysis was carried out according to the results of tests for cone penetration (CPT). The analysis of the obtained results showed that the dynamic DLT method (according to GOST) compared with static SLT (according to GOST) and cone-penetrating tests (CPT, according to GOST) showed a low bearing capacity of about 30-40 percent. According to comparative analyzes, the static testing method of piles was determined to differ from the CPT by about 15 percent. These investigations are important for the understanding of soil-structure interaction, especially of boring and driven piles in construction site Astana.
CPT , DLT , High-rise building , Pile , SLT
Text of the article Перейти на текст статьи
Department of Civil Engineering, L.N. Gumilyov Eurasian National University, Kazakhstan
Department of Civil Engineering
10 лет помогаем публиковать статьи Международный издатель
Книга Публикация научной статьи Волощук 2026 Book Publication of a scientific article 2026