Studying foundry resin-bonded sand molds made with the use of variable pressure
Dostayeva A. Kulikov V. Baibekov S. Kovalev P. Kvon S. Issagulov A. Arinova S. Kovaleva T.
2025SciCell s.r.o.
Acta Metallurgica Slovaca
2025#31Issue 3149 - 155 pp.
It is known that most casting molds are made using a binder. To exhibit its effect, the binder additive must initially be in the liquid state, then form a film on the surface of the solid phase, develop a cuff around the contact points between the grains, and solidify, thereby turning the bulk mixture into a monolithic medium. Sand-resin mixtures meet all these requirements. Casting molds made from such mixtures enable the production of high-quality castings from a wide range of alloys. However, their widespread industrial application is hindered by the relatively high cost of the binder, pulverbakelite. Therefore, research aimed at improving the manufacturing processes of durable sand-resin molds while reducing the content in the mixture, without compromising other parameters, is highly relevant.
casting molds , density , gas permeability , pressure , pulverbakelite , sand-resin mixtures , tensile strength
Text of the article Перейти на текст статьи
Karaganda Technical University named after Abilkas Saginov, Department of Nanotechnology and Metallurgy, Nursultan Nazarbayev Avenue No. 56, Karaganda, 100003, Kazakhstan
NRU Peter the Great St. Petersburg Polytechnic University, Institute of Mechanical Engineering, Materials and Transport, Polytechnic street No. 29B, Saint Petersburg, 1940216, Russian Federation
Karaganda Technical University named after Abilkas Saginov
NRU Peter the Great St. Petersburg Polytechnic University
10 лет помогаем публиковать статьи Международный издатель
Книга Публикация научной статьи Волощук 2026 Book Publication of a scientific article 2026