Development of a method for calculating the degree of use of the plasticity resource (Dupr) when rolling on a new continuous mill
Azilkiyasheva M.M. Shayakhmetov S.B. Bakyt G.B. Kopenov B.T. Smailova G.A. Baubekov Y.Y. Zhauyt A.
July 2021Faculty of Metallurgy
Metalurgija
2021#60Issue 3-4362 - 364 pp.
A new design of a continuous mill is proposed in the article. A method has been developed for calculating the degree of use of the plasticity resource when rolling thin slabs on a new continuous mill using the data obtained in the MSC Super Forge environment. To determine the stress-strain state, it used measurement data in 5 stands. When rolling in the proposed mill steel D16 there is no violation of the continuity of the strip material. This is proved by calculation in the MSC Super Forge environment using the distribution of DUPR over the cross section of strips when rolling in a mill of a new design.
Plasticity , Rolling , Steel , Stress-strain , Strip
Text of the article Перейти на текст статьи
Almaty University of Power Engineering and Telecommunications, Almaty, Kazakhstan
Kazakh National Agrarian Research University, Almaty, Kazakhstan
Kazakh Academy of Transport and Communications named after M.Tynyshpayev, Almaty, Kazakhstan
Almaty University of Power Engineering and Telecommunications
Kazakh National Agrarian Research University
Kazakh Academy of Transport and Communications named after M.Tynyshpayev
10 лет помогаем публиковать статьи Международный издатель
Книга Публикация научной статьи Волощук 2026 Book Publication of a scientific article 2026