Using the Method of Probabilistic Deterministic Experiment to Assess the Impact of Alloying Elements on the Properties of the Quasi High-Entropy Alloy of the Fe-Cr-Ni-Co-Mn System
Abildina A.R. Issagulov A.Z. Shcherbakova Y.P. Кvon S.S.
2025Abylkas Saginov Karaganda Technical University
Material and Mechanical Engineering Technology
2025#2025Issue 156 - 64 pp.
This article considers the issues of planning experiments in testing wear resistance, hardness and tensile strength of the Cantor alloy. Basic experiments were carried out and an experimental matrix was developed. An experimental planning matrix was developed and calculated to conduct the basic experiments. The input and output parameters of the experiment were determined. The following were selected as input parameters: the niobium content from 14 to 18%; the carbon content from 1.5 to 2.5%; press pressure from 80 to 100 MPa. The output parameters were wear resistance, hardness and tensile strength. As a result, a six-factor matrix of experiments on five levels was used, in which three factors were vacant. Based on the data obtained, experiments were carried out on smelting an experimental quasi high-entropy alloy of the CoCrFeMnNi system with different niobium contents under laboratory conditions.
alloying elements , Cantor alloy , correlation , experiment planning , factors , hardness , high-entropy alloy , press pressure , wear resistance
Text of the article Перейти на текст статьи
Abylkas Saginov Karaganda Technical University, Karaganda, Kazakhstan
Kaliningrad State Technical University, Kaliningrad, Russian Federation
Abylkas Saginov Karaganda Technical University
Kaliningrad State Technical University
10 лет помогаем публиковать статьи Международный издатель
Книга Публикация научной статьи Волощук 2026 Book Publication of a scientific article 2026